<html><head><meta http-equiv="content-type" content="text/html; charset=utf-8"></head><body dir="auto"><div></div><div>Hank,</div><div>yes very patient "lol" as this might not be the final version.</div><div>I have tested the motor out of the housing in a bucket of oil & established</div><div>that it could only be run at 30 Amps without overheating. It causes quite </div><div>a turbulence running in oil with no prop on due to the open design of a rotating </div><div>back section. It will want to force oil out of the housing & up the oil feed tube,</div><div>but I am hoping the overpressure from my oil compensator will keep the oil</div><div>in around the motor. </div><div>Am learning a lot on each attempt.</div><div>Alan</div><div><br></div><div><br></div><div><br>On 3/10/2018, at 9:06 PM, hank pronk via Personal_Submersibles <<a href="mailto:personal_submersibles@psubs.org">personal_submersibles@psubs.org</a>> wrote:<br><br></div><blockquote type="cite"><div><div style="font-family:Helvetica Neue, Helvetica, Arial, sans-serif;font-size:13px;"><div>Alan, your patience is amazing. I would be itching to test it before sending it away for anodizing. </div><div>Hank</div><div style="font-family:Helvetica Neue, Helvetica, Arial, sans-serif;font-size:13px;"></div></div></div></blockquote><blockquote type="cite"><div><span>_______________________________________________</span><br><span>Personal_Submersibles mailing list</span><br><span><a href="mailto:Personal_Submersibles@psubs.org">Personal_Submersibles@psubs.org</a></span><br><span><a href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles">http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles</a></span><br></div></blockquote></body></html>