<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>James,    how does the flange seal to the tube?</DIV><DIV> </DIV><DIV>Brian</DIV><DIV><BR><BR>--- personal_submersibles@psubs.org wrote:<BR><BR>From: James Frankland via Personal_Submersibles <personal_submersibles@psubs.org><BR>To: Personal Submersibles General Discussion <personal_submersibles@psubs.org><BR>Subject: [PSUBS-MAILIST] Battery Pods Question<BR>Date: Tue, 12 Jun 2018 12:44:26 +0100<BR><BR></DIV><DIV dir="ltr"><DIV>Hi All</DIV><DIV><BR></DIV><DIV>I am making new battery pods for Skadoc.  I am thinking of making the removable ends slightly different to how I did it on the K.  On that, I put the flanges on to make like a standard flanged end.  However, I made them like you would a hatch, ie with the centre of the flange being welded to the centre of the tube.  So there is overlap on both sides of the ID and OD of the tube.  Bit difficult to explain.  Pic here of the K ones when I was making them.</DIV><DIV><BR></DIV><DIV><DIV><IMG width="364" height="280" src="cid:20180612063708.D254EC2F@m0117460.ppops.net">  K350 pod ends.</DIV><DIV><BR></DIV><DIV>The problem with these is that the overlap onto the inside diameter of the tube makes the hole smaller and you cant slide the trays out.</DIV><DIV><BR></DIV><DIV>With the new one, I have made rolling trays and I want them to slide straight out.  </DIV><DIV><BR>So, I am thinking I can make the flanges flush with the inside diameter of the tube.</DIV><DIV><BR></DIV><DIV>I have not started this part yet, so any advice greatly appreciated.</DIV><DIV><BR></DIV><DIV><DIV><IMG width="403" height="535" src="cid:20180612063708.D254EC20@m0117460.ppops.net"><BR>​</DIV><DIV>Not a very good picture, but new trays with rollers made.  </DIV></DIV><DIV><BR></DIV><DIV>Thanks</DIV><DIV>James</DIV><DIV><BR></DIV><DIV><BR></DIV><DIV><BR>​</DIV></DIV></DIV>

--000000000000676ea3056e7063d8--_______________________________________________
Personal_Submersibles mailing list
<A href="/eonapps/ft/wm/page/compose?send_to=Personal_Submersibles%40psubs.org">Personal_Submersibles@psubs.org</A>
<A href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles">http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles</A>
</DIV>