<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>Hi All,          I did an experiment today with my hatch because I'm trying to get a handle on the sealing capability of my hatch.  My hatch dogs are on a wheel that I turn to secure them, they are only a friction progressive seal, where the dogs push the hatch down tight from the underneath the rim of the hatch rim.  I'm concerned that if I were lingering right at where the water level meets the hatch ring that there might not be enough pressure to seal and I would have a leak.  I also wanted to see my cabin pressure gauge move as well so I brought a scuba tank inside the cabin to build up pressure inside.  I used some ratchet straps to secure the hatch from the inside and was able to build up some positive pressure inside the cabin.  Then I tried just holding onto the hatch closure wheel with my weight to see if I could get a pressure increase that way, which I did.  Do you experienced submariners ever have an initial leak at the hatch before there is sufficient pressure to seal?  It would be nice to do a negative pressure like Nuytco does but I can't figure out how to do that while I'm inside the sub.</DIV><DIV> </DIV><DIV>Brian</DIV><DIV> </DIV><DIV>  </DIV></DIV>