<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>Here is the source of my pin hole leaks.   Some areas at the center where the rebar did not get completely filled with cement left a slight void.  Most areas were good but where I had bolt holes going through the holes would intersect the void and give a path to air or water.  This is probably due to having the cement too dry when plastering.  It's a delicate balance , if the cement is too wet it won't adhere properly, too dry and you get voids like shown.  If I did it again I would blast the whole thing with a pressure cement sprayer , let that set up and then go back over it with regular plastering.    But for the most part I did get good penetration.</DIV><DIV> </DIV><DIV>Brian</DIV></DIV>