<div dir="auto">Hi Brian, are there any concerns about the voids in the cement when at depth?</div><div class="gmail_extra"><br><div class="gmail_quote">On Dec 12, 2017 1:41 PM, "Brian Cox via Personal_Submersibles" <<a href="mailto:personal_submersibles@psubs.org">personal_submersibles@psubs.org</a>> wrote:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div style="font-family:Arial,sans-serif;font-size:10pt"><div>Here is the source of my pin hole leaks.   Some areas at the center where the rebar did not get completely filled with cement left a slight void.  Most areas were good but where I had bolt holes going through the holes would intersect the void and give a path to air or water.  This is probably due to having the cement too dry when plastering.  It's a delicate balance , if the cement is too wet it won't adhere properly, too dry and you get voids like shown.  If I did it again I would blast the whole thing with a pressure cement sprayer , let that set up and then go back over it with regular plastering.    But for the most part I did get good penetration.</div><div> </div><div>Brian</div></div><br>______________________________<wbr>_________________<br>
Personal_Submersibles mailing list<br>
<a href="mailto:Personal_Submersibles@psubs.org">Personal_Submersibles@psubs.<wbr>org</a><br>
<a href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles" rel="noreferrer" target="_blank">http://www.psubs.org/mailman/<wbr>listinfo.cgi/personal_<wbr>submersibles</a><br>
<br></blockquote></div></div>