<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>Alan,     Will you have a mechanical valve for back up ?</DIV><DIV> </DIV><DIV>Brian<BR><BR>--- personal_submersibles@psubs.org wrote:<BR><BR>From: Alan James via Personal_Submersibles <personal_submersibles@psubs.org><BR>To: Personal Submersibles General Discussion <personal_submersibles@psubs.org><BR>Subject: [PSUBS-MAILIST] SOLENOID BALLAST VALVE<BR>Date: Tue, 18 Oct 2016 07:43:50 +0000 (UTC)<BR><BR></DIV><DIV style="color: rgb(0, 0, 0); font-family: HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif; font-size: 16px; background-color: rgb(255, 255, 255);"><DIV>I have been working on my ballast valve design. (below)</DIV><DIV dir="ltr">It's based on the drawing Vance handed out at the Islamorada convention, </DIV><DIV dir="ltr">except it's operated by a solenoid rather than an air cylinder.</DIV><DIV dir="ltr">I am intending to have a similar valve on the bottom of my ballast tank,</DIV><DIV dir="ltr">but modified so that the sealing gasket sits on the outside of the top plate</DIV><DIV dir="ltr">& pushes away. </DIV><DIV dir="ltr">I will be able to use the same wire on the top valve on the coil of the bottom</DIV><DIV dir="ltr">valve so they work in unison. Just a matter of getting the right thickness</DIV><DIV dir="ltr">of wire & number of turns. </DIV><DIV dir="ltr">If it fails you won't be able to release air to dive, but will always be able to</DIV><DIV dir="ltr">fill the tanks with air.</DIV><DIV dir="ltr">The iron core of the plunger will need to be coated. The wiring of the solenoid</DIV><DIV dir="ltr">is already coated but I'll add a bit of epoxy.</DIV><DIV dir="ltr">The intended assembly method is to cut a whole in the top of the ballast tank</DIV><DIV dir="ltr">& drop the module in. Then use the bolt holes in the top plate as a template</DIV><DIV dir="ltr">for holes through the ballast tank. The ballast tank holes are then oversized</DIV><DIV dir="ltr">to receive threaded inserts that are epoxied in from the inside. Then the valve</DIV><DIV dir="ltr">is dropped in & bolted down.</DIV><DIV dir="ltr">I am thinking of doing it all in hard anodized aluminum but are not quite sure.</DIV><DIV dir="ltr">I am intending to weld the body to the top plate.</DIV><DIV dir="ltr">Any thoughts???</DIV><DIV dir="ltr">Alan <BR></DIV></DIV>_______________________________________________
Personal_Submersibles mailing list
<A href="/eonapps/ft/wm/page/compose?send_to=Personal_Submersibles%40psubs.org">Personal_Submersibles@psubs.org</A>
<A href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles">http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles</A>
</DIV>