<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>Jon,    Does the Delron fit into the machined bore of the thru hull?  </DIV><DIV> </DIV><DIV>Brian<BR><BR>--- personal_submersibles@psubs.org wrote:<BR><BR>From: Jon Wallace via Personal_Submersibles <personal_submersibles@psubs.org><BR>To: Personal Submersibles General Discussion <personal_submersibles@psubs.org><BR>Subject: Re: [PSUBS-MAILIST] Electrical thru-hull<BR>Date: Sun, 7 Feb 2016 11:41:48 -0500<BR><BR>
  
  
    </DIV><DIV><BR>
      Hank, I need penetrators for 36vdc power to motors (50amp), 12vdc
      power to lights (20amp), and other small electronic sensors.   Any
      thoughts about delron or nylon as a body for machining.  Attached
      is a design for threaded rod through delron that I came up.  The
      nuts on the threaded rod probably not necessary if locktite or
      epoxy is used on the threads before driving it into the thru-hull
      body.<BR>
      <BR>
      Jon<BR>
      <BR>
      <BR>
      <BR>
      On 2/6/2016 2:24 PM, hank pronk via Personal_Submersibles wrote:<BR>
    </DIV>
    <BLOCKQUOTE>
      <TABLE border="0" cellspacing="0" cellpadding="0">
        <TBODY>
          <TR>
            <TD valign="top">
              <DIV>Jon,<BR>
                What do you have to work with in terms of hole in hull.
                What amp are you trying to run through.<BR>
                Hank</DIV>
            </TD>
          </TR>
        </TBODY>
      </TABLE>
      <BR>
    </BLOCKQUOTE>
    <BR>
  

_______________________________________________
Personal_Submersibles mailing list
<A href="/eonapps/ft/wm/page/compose?send_to=Personal_Submersibles%40psubs.org">Personal_Submersibles@psubs.org</A>
<A href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles">http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles</A>
</DIV>