<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>Hank,</DIV><DIV>            Here are all my penetrations:</DIV><DIV> </DIV><DIV>Front hard ballast tank</DIV><DIV> 1.   flood valve -  1/2" ss rod thru hull </DIV><DIV> 2.   vent valve</DIV><DIV> 3.  air inject    -  ss coupling</DIV><DIV> </DIV><DIV>Main ballast tank (soft)</DIV><DIV> 1. flood valve  - ss 1/2" rod thru hull</DIV><DIV> 2. air inject</DIV><DIV> </DIV><DIV>mechanical penetrations:</DIV><DIV>  1.  front flaps       - ss 1/2" rod thru hull  (all)</DIV><DIV>  2. back flaps</DIV><DIV>  3. motor turning   ( steering )</DIV><DIV> </DIV><DIV>Breathing Oxygen  -  3/4" coupling  or smaller  ( will bush)</DIV><DIV> </DIV><DIV>Flood Valve  - 1 1/2"  - ss coupling  ( near bottom)</DIV><DIV> </DIV><DIV>main ballast HP air in   - </DIV><DIV>  #1 - 3/4"  ss coupling</DIV><DIV>  #2 - 3/4"     ( will have bushings to 1/2" or smaller)</DIV><DIV> </DIV><DIV> </DIV><DIV>Gauges</DIV><DIV>  1.  Temperature  - 1/2"   ss coupling</DIV><DIV>   2.  Pressure -    1/2"</DIV><DIV> </DIV><DIV>Release buoy </DIV><DIV>  1.  1/2" SS rod thru hull</DIV><DIV> </DIV><DIV>Equalizing valve  </DIV><DIV>  1.  3/4" coupling</DIV><DIV> </DIV><DIV>Drop weight</DIV><DIV>   1.  7/8" ss rod thu hull</DIV><DIV> </DIV><DIV>Hatch dog thu hull</DIV><DIV> 1.  7/8" ss rod</DIV><DIV> </DIV><DIV> Is there anything that I obviously forgot ??      All my electrical will be going through a separate viewport fitting.</DIV><DIV> </DIV><DIV>So far I have the front trim, hatch , but no air yet.</DIV><DIV> </DIV><DIV>Not sure if I want to have a small trim tank in the main cabin or not.</DIV><DIV> </DIV><DIV> </DIV><DIV>Brian</DIV><DIV> </DIV><DIV> </DIV><DIV> </DIV><DIV> </DIV><DIV> </DIV><DIV> </DIV></DIV>