<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>You can do it like you suggest, in fact that is how it is usually done, I believe.  What are the dimensions of the groove you need?</DIV><DIV> </DIV><DIV>Brian <BR><BR>--- personal_submersibles@psubs.org wrote:<BR><BR>From: hank pronk via Personal_Submersibles <personal_submersibles@psubs.org><BR>To: Personal Submersibles General Discussion <personal_submersibles@psubs.org><BR>Subject: [PSUBS-MAILIST] o-ring groove<BR>Date: Wed, 12 Aug 2015 22:16:12 +0000 (UTC)<BR><BR></DIV><DIV style="color: rgb(0, 0, 0); font-family: HelveticaNeue, Helvetica Neue, Helvetica, Arial, Lucida Grande, sans-serif; font-size: 12px; background-color: rgb(255, 255, 255);"><DIV>Brian,</DIV><DIV>Did you sort out the boring bar for cutting inside o-ring grooves?   I need to do the same and could use some advice, I was going to make a boring bar cutter with a very narrow cutter, narrower than the required groove and do multiple cuts.  I tried to make a groove cutter that was the full groove width but it was to much.   </DIV><DIV>Hank</DIV></DIV>_______________________________________________
Personal_Submersibles mailing list
<A href="/eonapps/ft/wm/page/compose?send_to=Personal_Submersibles%40psubs.org">Personal_Submersibles@psubs.org</A>
<A href="http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles">http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles</A>
</DIV>