<div dir="ltr">Hi,<div><br></div><div>I`m in the process of ordering the shell and tower for my submarine.</div><div>What specification should I ask for? (Europe) </div><div><br></div><div><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px"> I asked for </span><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px">EN10204 with 3.1 Sertificate (Not 100% sure of this, but this is what I got when I ordered the endcaps from another company. 3.2 Sertificate was a bit too expensive)</span><br></div><div><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px">Told them I had no special requirements for the plates and needed no edge preperation.</span><br></div><div><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px"><br></span></div><div><b>They replied</b>:<span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px"> "this is not the normal enquiry type, but we will not ask any longer" (?)</span></div><div>And said the plates was going to be <span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px">EN10028-3 with certificate 3.2.</span></div><div><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px"><br></span></div><div><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px">I want to keep the cost down, b</span><span style="color:rgb(0,0,0);font-family:Verdana,Arial,Helvetica;font-size:11px">ut should I ask that they grit blast the shell after rolling?</span></div><div>Also I didn`t ask for bevel on the edges. Again to keep cost down. But maybe I should, to spare me the extra work?</div><div><br></div><div>May I ask what you tell your supplier when ordrering?</div><div><br></div><div><br></div><div>-André</div></div>