<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><DIV>Previous pics</DIV><DIV> </DIV><DIV>These are the windings before they have been dipped in the epoxy.  Also a picture of the stainless housing.  The ends of these motors are made from aluminum, they plan to anodize them so they will be resistant to corrosion, They may need some additional epoxy coating just for good measure if they are to go in salt water.  But it appears to me these motors are ready "as is" to go directly into the water without a pod, there may be a bit of tinkering with where the three AWG (3/0) wires come into the motor and the encoder wires ( 6 small wires).  There would have to be some sort of seal in that area but I don't think that will be a problem.    the controller would be inside the sub, the controller converts the 48 DC voltage to a 3 phase AC   </DIV></DIV>