<div dir="ltr"><div>Hi Bob,</div><div>I had exactly the same problems.  As others have said, forget the honing tool.    I used the appropriate sized hand reamer.  (A normal one, not an adjustable which are a bit of a pain to use).  I ran the reamer through and then I used a bar with a slot cut in it and a piece of very fine emery paper (wet) through the slot to take off the smallest amounts until the fitting went through.  Worked fine.</div><div> </div><div>Have a picture here.  </div><div><a href="http://www.guernseysubmarine.com/Extended_files/Page23356.htm">http://www.guernseysubmarine.com/Extended_files/Page23356.htm</a></div><div>Hope this helps, </div><div>Good luck</div><div>James</div><div> </div></div>