<html><body><div style="font-family: Arial; font-size: 12pt; color: #000000"><DIV aria-label="Compose body">Thanks for all the input. I am going to try it this weekend and will give you all an update!!<BR></DIV>
<DIV><BR></DIV>
<HR id=zwchr>
<DIV style="FONT-SIZE: 12pt; FONT-FAMILY: Helvetica,Arial,sans-serif; FONT-WEIGHT: normal; COLOR: #000; FONT-STYLE: normal; TEXT-DECORATION: none" data-mce-style="color: #000; font-weight: normal; font-style: normal; text-decoration: none; font-family: Helvetica,Arial,sans-serif; font-size: 12pt;"><B>From: </B>"submersibles, personal" <personal_submersibles@psubs.org><BR><B>To: </B>"submersibles, personal" <personal_submersibles@psubs.org><BR><B>Sent: </B>Thursday, October 9, 2014 2:50:45 AM<BR><B>Subject: </B>Re: [PSUBS-MAILIST] Electrical thru-hull<BR>
<DIV><BR></DIV>
<DIV dir=ltr>
<DIV>Hi Bob,</DIV>
<DIV>I had exactly the same problems. As others have said, forget the honing tool. I used the appropriate sized hand reamer. (A normal one, not an adjustable which are a bit of a pain to use). I ran the reamer through and then I used a bar with a slot cut in it and a piece of very fine emery paper (wet) through the slot to take off the smallest amounts until the fitting went through. Worked fine.</DIV>
<DIV> </DIV>
<DIV>Have a picture here. </DIV>
<DIV><A href="http://www.guernseysubmarine.com/Extended_files/Page23356.htm" target=_blank data-mce-href="http://www.guernseysubmarine.com/Extended_files/Page23356.htm">http://www.guernseysubmarine.com/Extended_files/Page23356.htm</A></DIV>
<DIV>Hope this helps,</DIV>
<DIV>Good luck</DIV>
<DIV>James</DIV>
<DIV> </DIV></DIV><BR>_______________________________________________<BR>Personal_Submersibles mailing list<BR>Personal_Submersibles@psubs.org<BR>http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles<BR></DIV>
<DIV><BR></DIV></div></body></html>