<DIV>Hi Dan:</DIV>
<DIV> </DIV>
<DIV>Sorry for the confusion, a run on sentence will do that. I was asking about the size/cross-section of the O-ring. The 316 stainless steel ring would be welded to the dish lid in which the O-ring would be mounted using a machined dove-tail grove,   </DIV>
<DIV> </DIV>
<DIV>Thanks for the input.</DIV>
<DIV> </DIV>
<DIV>John K.</DIV>
<DIV> <BR><BR>----- Original Message -----<BR>From: "Dan H." <JUMACHINE@COMCAST.NET><BR>Date: Wednesday, September 18, 2013 7:07 pm<BR>Subject: Re: [PSUBS-MAILIST] O-rings<BR>To: Personal Submersibles General Discussion <PERSONAL_SUBMERSIBLES@PSUBS.ORG><BR><BR>> John,<BR>> <BR>> Are you sure you really want an O-ring with a one inch cross <BR>> section??????????You'd need to machine a groove just under an <BR>> inch deep and an inch in across to accept it. If your hatch <BR>> cover is what the print calls for, it's not think enough for a <BR>> groove of that size. <BR>> <BR>> The .275 cross section is plenty. The two mating surfaces being <BR>> flat and mating with no gap is much more important then the O-<BR>> ring cross section. <BR>> <BR>> You should be fine with the O-ring called for. <BR>> <BR>> Dan H.<BR>> ----- Original Message ----- <BR>> From: subvet596@optonline.net <BR>> To: PSUBS, Inc. <BR>> Sent: Wednesday, September 18, 2013 3:35 PM<BR>> Subject: [PSUBS-MAILIST] O-rings<BR>> <BR>> <BR>> Hi All:<BR>> <BR>> I need O-rings for the entry hatches which are 24" id. 26" od. <BR>> he question I have is, what is the best cross section size to <BR>> use The parker site has the E1157 @ .275 it seemed a little <BR>> small to me. I have not yet machined the dove -tail grove yet. <BR>> Also are there any specs. available for setting up a 3 dog <BR>> mechanism, able to open from inside or out? <BR>> <BR>> Looking forward to the convention.<BR>> <BR>> <BR>> John K.<BR>> (203) 414-1000<BR>> <BR>> <BR>> <BR>> -----------------------------------------------------------------<BR>> -------------<BR>> <BR>> <BR>> _______________________________________________<BR>> Personal_Submersibles mailing list<BR>> Personal_Submersibles@psubs.org<BR>> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles<BR>> </DIV>