[PSUBS-MAILIST] Pre-machined Acrylic Prep

hank pronk via Personal_Submersibles personal_submersibles at psubs.org
Fri Sep 2 14:42:31 EDT 2022


Jon, yes I did and it was no problem, especially for you.  
Hank

Sent from my iPhone

> On Sep 2, 2022, at 8:55 AM, Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
> 
> 
> Anyone out there normalizing their acrylic?
> 
> Section 15 of Stachiw's Handbook of Acrylic is dedicated to stress relieving processes for acrylic viewports.  Stachiw states that such stress relief is required to reduce the premature crazing and failure of acrylic surfaces.  Section 15.2.1 discusses "normalization" of the material and how it both relieves stress and changes the physical properties of it.  The amount of time required to heat, bake, and cool the acrylic material depends upon thickness, but is lengthy in all cases.  I have reached out to numerous acrylic molders in New England and found that none of them have ovens that meet the technical requirements for proper normalization or annealing as described by Stachiw.  That leads me to the conclusion that I'm probably/definitely going to have to build my own oven for such purposes.  I think Hank did build such an oven but I haven't heard of anyone else doing so.
> 
> 
> Jon
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20220902/44e37d38/attachment.html>


More information about the Personal_Submersibles mailing list