[PSUBS-MAILIST] Fwd:

[hank pronk via Personal_Submersibles]

 David,Thanks' next is the dome.   Today I am starting to make the radius cutting attachment for my lathe.  I have come up with a design that incorporates a 24V wheelchair motor and gearhead.  The cutting tool will pivot off the output shaft from the motor assembly.  If it works, I can cut both the inside and outside radius of the dome with one tool.  My acrylic block has arrived in Montana from Reynolds Polymer, so I have to drive down and pick it up Monday.Hank
    On Thursday, August 22, 2019, 11:24:37 PM MDT, David Colombo via Personal_Submersibles <personal_submersibles at psubs.org> wrote:  
 
 Hank, you amaze me. Whats next?David
On Thu, Aug 22, 2019, 2:32 PM hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

Mission accomplished. This is the new seat after machining to 90 degrees and boring out to 11.5 inches. Hank

Sent from my iPhone
Begin forwarded message:


From: hank pronk <hanker_20032000 at yahoo.ca>
Date: August 22, 2019 at 2:55:00 PM MDT
To: hank pronk <hanker_20032000 at yahoo.ca>











Sent from my iPhone
_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles

_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20190823/f00dd3f4/attachment.html>